گروه فراساز

---

---

---

farasaz group

 FA EN

Farasaz test station

Farasaz Company test station was established in 1995 in order to perform type testing of transmission towers and similar structures. The  equipment and facilities of this station make it possible to apply forces simultaneously in three directions, longitudinal, transverse and vertical in different places and be able to measure and read them. Measuring forces using load cell or dynamo meter . The digital is load cell  located between the point of application and the electric motors or forceps. The force measured by the load cells is transmitted to the hardware of the control room and can be seen in the monitoring system.

Farasaz test station was initially established only to test rigs designed by Farasaz, but with the development of different parts of the station and also after successful testing of various rigs and gaining trust among the country's industrial circles,now has many customers .

Farasaz test station is located 35 km from Esfahan  provice and near the Morche Khort.

Description of Farasaz test station

Two gantry devices are used to apply transverse and longitudinal forces. The transverse gantry is located at a distance of 50 meters and the longitudinal gantry is located at a distance of 42 meters from the test rig. The task of these gantries is to change the direction of the force applied by the wing to a definite and mostly horizontal slope.

This is possible by passing the power cable through the hanging gantry. Farasaz test station has a foundation on which it is possible to install mesh towers and monopoly towers. Farasaz test station has a multi purpose foundation, it is possible to install every kind of lattice towers and monopole towers. Three sets of Winches are provided at the test station to apply transverse, longitudinal and vertical forces. An electric motor is provided for each winch and a foundation is provided for each series of winches.

Total longitudinal and vertical winches adjacent to the longitudinal gantry and transverse winches adjacent to the transverse gantry. A crane with 50 tons capacity   & 50M height is used to install the test towers. Two theodolite devices are used to read transverse and longitudinal places.

Control room of Farasaz test station

This  control room is equipped with electric motor  & control system, hardware system and load cell monitoring and computer. During a test, the tester observes the force information in the monitoring system and gives the necessary instructions to the electric motors.  in this time controller see the results in another monitor.

In Farasaz test station, the forces that enter the structure in real conditions, enter to tower and the tower is tested in real conditions.

 This station is also ready to carry out destruction tests, but due to the possible damages that will be inflicted on the station during the testing, these tests will be carried out in compliance with the principles and rules, as well as tacit agreemen

Equipment of Farasaz test station

In Farasaz test station, all the necessary facilities have been provided for testing various structures, especially lattice towers and telescopic power transmission, which are mentioned as part of the facilities and equipment as follows:

  • Possibility to apply the 30 tons maximum force applicable at one point.
  • Possibility to apply the maximum number of forces ( 32 forces) that can be applied simultaneously.
  • Foundation with the ability to test a variety of lattice and telescopic towers.
  • Ability to test mesh towers with base dimensions of 25 by 25 meters.
  • Ability to test monopoly towers with base dimensions of 3.5 meters.
  • Ability to test the rig up to a height of 70 meters.
  • Possibility to test the rig up to 30 meters wide.
  • 21 10-ton engines and 10 5-ton engines and engine control system.
  • 21 load cells of 20 tons and 5 load cells of 10 tons and 7 load cells of 5 tons and hardware system and monitoring of load cells.

Steps to perform type test

After receiving the information related to the rig, the engineers of the test station check how the test is performed and present the test method and related documents to the employer in a booklet as a test procedure. After approval of the test booklet, the technical staff of the test station will start preparing the test station according to the plans provided in it, which includes cabling, calibration of load cells, assembly and installation of the test tower, and 50% test. After preparing the test station with the presence of representatives of the project employer, consulting companies and the test employer will perform the test operation in a period of 1 to 3 days. Is sent to the employer in a booklet called the test report.

 Contact us:

 P.O.Box: 476934769

 PHONE : 009821-44604000

 FAX: 009821-44604010

 EMAIL: info@farasaz.com

 Instagram: farasaz.group

 Linkeddinfarasaz.group

گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
farasaz group
گروه فراساز
type test station of towers
گروه فراساز
farasaz group
type test station of towers
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
farasaz group
type test station of towers
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers
گروه فراساز
farasaz group
type test station of towers